show rmon channel
SecureStack B3 Configuration Guide 14-15
show rmon channel
UsethiscommandtodisplayRMONchannelentriesforoneormoreports.
Syntax
show rmon channel [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,informationaboutallchannelswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayRMONchannelinformationforge.2.12:
B3(rw)->show rmon channel ge.2.12
Port ge.2.12 Channel index= 628 EntryStatus= valid
----------------------------------------------------------
Control off AcceptType matched
OnEventIndex 0 OffEventIndex 0
EventIndex 0 Status ready
Matches 4498
Description Thu Dec 16 12:57:32 EST 2004
Owner NetSight smith
set rmon channel
UsethiscommandtoconfigureanRMONchannelentry.
Syntax
set rmon channel index port-string [ accept { matched | failed}] [control { on | off}]
[description description] [owner owner]
Parameters
show rmon filter 14-17
set rmon filter 14-17
clear rmon filter 14-18
For information about... Refer to page...
port‐string (Optional)DisplaysRMONchannelentriesforaspeci ficport(s).
index Specifiesanindexnumberforthisentry.Anentrywillautomaticallybe
createdifanunusedindexnumberischosen.Maximumnumberof
entriesis2.Maximumvalueis65535.
port‐string Specifiestheportonwhichtrafficwillbemonitored.
To Next Page
Loading...
Need help?
General