Enterasys SecureStack B3

set pwa guestname
SecureStack B3 Configuration Guide 20-63
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetathePWAprotocoltoCHAP:
B3(su)->set pwa protocol chap
set pwa guestname
UsethiscommandtosetaguestusernameforPWAnetworking.PWAwillusethisnametogrant
networkaccesstoguestswithoutestablishedloginnamesandpasswords.
Syntax
set pwa guestname name
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetthePWAguestusernameto“guestuser”:
B3(su)->set pwa guestname guestuser
clear pwa guestname
UsethiscommandtoclearthePWAguestusername.
Syntax
clear pwa guestname
chap|pap SetsthePWAprotocolto:
•CHAP(PPPChallengeHandshakeProtocol)‐encryptstheusername
andpasswordbetweentheend‐stationandtheswitchport.
•PAP(PasswordAuthenticationProtocol‐doesnotprovideany
encryptionbetweentheend‐stationtheswitchport.
name Specifiesaguestusername.