To Next Page

To Previous Page

set arp

13-16 Logging and Network Management

Example

ThisexampleshowshowtodisplaytheARPtable:

B3(su)->show arp

LINK LEVEL ARP TABLE

IP Address Phys Address Flags Interface

-----------------------------------------------------

10.20.1.1 00-00-5e-00-01-1 S host

134.142.21.194 00-00-5e-00-01-1 S host

134.142.191.192 00-00-5e-00-01-1 S host

134.142.192.18 00-00-5e-00-01-1 S host

134.142.192.119 00-00-5e-00-01-1 S host

-----------------------------------------------------

Table 13‐4providesanexplanationofthecommandoutput.

set arp

Usethiscommandtoaddmappingentriestotheswitch’sARPtable.

Syntax

set arp ip-address mac-address

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Example

ThisexampleshowshowtomapIPaddress192.168.219.232toMACaddress00‐00‐0c‐40‐0f‐bc:

B3(su)->set arp 192.168.219.232 00-00-0c-40-0f-bc

Table 13-4 show arp Output Details

Output What It Displays...

IP Address IP address mapped to MAC address.

Phys Address MAC address mapped to IP address.

Flags Route status. Possible values and their definitions include:

S - manually configured entry (static)

P - respond to ARP requests for this entry

ip‐address SpecifiestheIPaddresstomaptotheMACaddressandaddtotheARP

table.

mac‐address SpecifiestheMACaddresstomaptotheIPaddressandaddtotheARP 

table.TheMACaddresscanbeformattedasxx:xx:xx:xx:xx:xxorxx‐xx‐

xx‐xx‐xx‐xx.

Enterasys SecureStack B3 User Manual

Questions and Answers: