Enterasys SecureStack B3

clear spantree lptrapenable
SecureStack B3 Configuration Guide 7-49
Example
ThisexampleshowshowtodisplaythecurrentLoopProtecteventnotificationstatus:
B3(rw)->show spantree lptrapenable
The Loop Protect event notification status is enable
clear spantree lptrapenable
UsethiscommandtoreturntheLoopProtecteventnotificationstatetoitsdefaultstateof
disabled.
Syntax
clear spantree lptrapenable
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoresettheLoopProtecteventnotificationstatetothedefaultof
disabled.
B3(rw)->clear spantree lptrapenable
set spantree disputedbpduthreshold
UsethiscommandtosetthedisputedBPDUthreshold,whichisthenumberofdisputedBPDUs
thatmustbereceivedonagivenport/SIDuntiladisputedBPDUtrapissent.
Syntax
set spantree disputedbpduthreshold value
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
value SpecifiesthenumberofdisputedBPDUsthatmustbereceivedona
givenport/SIDtocauseadisputedBPDUtraptobesent.
Athresholdof0indicatesthattrapsshouldnotbesent.Thedefault
valueis0.