Enterasys SecureStack B3

show cos port-config
10-24 Policy Classification Configuration
show cos port-config
Usethiscommandtoshowinboundratelimitinggroupsandtheassignedports.
Syntax
show cos port-config [irl group-type-index]
Parameters
Defaults
Theshowcosport‐configcommandbyitselfwillshowallPortGroups.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowsallinboundratelimitingportgroups.Notethatportsge.1.1throughge.1.48
wereremovedfromthedefaultportgroup0.0whentheywereaddedtoportgroups1.0and2.0.
B3(su)->show cos port-config
Inbound Rate Limiting Port Configuration Entries
----------------------------------------------------------------------
Port Group Name :Default
Port Group :0
Port Type :0
Assigned Ports :none
----------------------------------------------------------------------
Port Group Name :Users
Port Group :1
Port Type :0
Assigned Ports :ge.1.1-46
----------------------------------------------------------------------
Port Group Name :Uplink
Port Group :2
Port Type :0
Assigned Ports :ge.1.47-48
----------------------------------------------------------------------
clear cos port-config
Usethiscommandtoclearinboundratelimitinggroupsorassignedports.
Syntax
clear cos port-config irl {all | group-type-index {[entry] | [name] [ports]}}
irl (Optional)Specifiesthatinboundratelimitingconfigurationinformation
shouldbedisplayed.
group‐type‐index (Optional)Showassignedportsforaspecificportgroup.Validentriesare
intheformofgroup#.port‐type.
Validvaluesforgroup#canrangefrom0to7.Validvaluesforport‐type
canrangefrom0
to1,althoughonlyporttype0iscurrentlysupported.
Forexample,portgroup3wouldbespecifiedas3.0.