Enterasys SecureStack B3

set sntp client
SecureStack B3 Configuration Guide 13-27
set sntp client
UsethiscommandtosettheSNTPoperationmode.
Syntax
set sntp client {broadcast | unicast | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoenableSNTPinbroadcastmode:
B3(su)->set sntp client broadcast
clear sntp client
UsethiscommandtocleartheSNTPclient’soperationalmode.
Syntax
clear sntp client
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocleartheSNTPclient’soperationalmode:
B3(su)->clear sntp client
broadcast EnablesSNTPinbroadcastclientmode.
unicast EnablesSNTPinunicast(point‐to‐point)clientmode.Inthismode,the
clientmustsupplytheIPaddressfromwhichtoretrievethecurrenttime.
disable DisablesSNTP.