Enterasys SecureStack B3

Assigning Policies to Service Ports
SecureStack B3 Configuration Guide 9-15
Assigning Policies to Service Ports
Purpose
ToreviewandassignDiffservpoliciesandtheirassociatedclassestoserviceports.
Commands
ThecommandsusedtoreviewandassignDiffservpoliciestoserviceportsarelistedbelowand
describedintheassociatedsectionasshown.
show diffserv service info
UsethiscommandtodisplayinformationaboutDiffservserviceports.
Syntax
show diffserv service info {summary | detailed port-string} {in}
Parameters
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplayasummaryofincomi ngDiffservserviceporttraffic:
B3(rw)->show diffserv service info summary in
DiffServ Admin Mode............................ Enable
Interface Direction OperStatus Policy Name
----------- ----------- ---------- ----------------------
ge.1.1 In Up admin
ge.1.2 In Up admin
ge.1.3 In Up admin
For information about... Refer to page...
show diffserv service info 9-15
show diffserv service stats 9-16
set diffserv service 9-16
summary DisplaysDiffservserviceportsummaryinformation.
detailedport ‐string Displaysdetailedinformationforaspecificport(s).
in Displaysinformationaboutincomingtraffic.