To Next Page

To Previous Page

clear snmp targetaddr

SecureStack B3 Configuration Guide 6-27

Defaults

Ifnotspecified,udpportwillbesetto162.

Ifnotspecified,maskwillbesetto255.255.255.255

Ifnotspecified,timeoutwillbesetto1500.

Ifnotspecified,numberofretrieswillbesetto3.

Iftaglistisnotspecified,nonewillbeset.

Ifnotspecified,storagetype

willbenonvolatile.

Mode

Switchcommand,read‐write.

Example

Thisexampleshowshowtoconfigureatrapnotificationcalled“TrapSink.”Thistrapnotification

willbesenttotheworkstation192.168.190.80(whichistargetaddress“tr”).Itwillusesecurityand

authorizationcriteriacontainedinatargetparametersentrycalled“v2cExampleParams”.For

moreinformationonconfiguringabasicSNMPtrap,

referto“CreatingaBasicSNMPTrap

Configuration”onpage 6‐36:

B3(su)->set snmp targetaddr tr 192.168.190.80 param v2cExampleParams taglist

TrapSink

clear snmp targetaddr

UsethiscommandtodeleteanSNMPtargetaddressentry.

Syntax

clear snmp targetaddr targetAddr

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Example

ThisexampleshowshowtoclearSNMPtargetaddressentry“tr”:

B3(su)->clear snmp targetaddr tr

targetAddr Specifiesthetargetaddressentrytodelete.

Enterasys SecureStack B3 User Manual

Questions and Answers: