Enterasys SecureStack B3 - Using and Configuring Webview; Purpose

Using and Configuring WebView
3-52 Basic Configuration
Parameters
Defaults
Ifallisnotspecified,stackingconfigurationparameterswillnotbecleared.
Mode
Switchcommand,read‐write.
Usage
ExecutingthiscommandwillcleartheconfigurationinbothNVRAMandonthememorycard,if
oneisinstalledontheswitch.
ThiscommandwillnotcleartheIPaddressoftheswitch.Usetheclearipaddresscommandto
cleartheIPaddress.
Whenusingtheclearconfigcommandtoclear
configurationparametersinastack,itisimportant
torememberthefollowing:
•UseclearconfigtoclearconfigurationparameterswithoutclearingstackunitIDs.This
commandWILLNOTclearstackparametersandavoidstheprocessofre‐numbering the
stack.
•Useclearconfigallwhenitisnecessarytoclearall
configurationparameters,includingstack
unitIDs(ifapplicable)andswitchpriorityvalues.
•UsetheclearipaddresscommandtocleartheIPaddress.
Configurationparametersandstackinginformationcanalsobeclearedonthemasterunitonlyby
selectingoption10(restoreconfigurationtofactorydefaults)fromthe bootmenuonswitch

startup.Thisselectionwillleavestackingprioritiesonallotherunits,ifapplicable.
Example
Thisexampleshowshowtoclearconfigurationparameters(includingstackingparameters,if
applicable):
B3(su)->clear config all
Using and Configuring WebView
Purpose
Bydefault,WebView(TheEnterasysNetworksembeddedwebserverforswitchconfiguration
andmanagementtasks)isenabledonTCPportnumber80ontheSecureStackB3switch.Youcan
verifyWebViewstatus,andenableordisableWebViewusingthecommandsdescribedinthis
section.WebViewcanalsobe securelyusedover
SSLport443,ifSSLisenabledontheswitch.By
default,SSLisdisabled.
TouseWebView,typetheIPaddressoftheswitchinyourbrowser.TouseWebViewoverSSL,
typeinhttps://thentheIPaddressoftheswitch.Forexample,https://172.16.2.10.
all (Optional)Clearsuser‐defined
configurationparameters(andstackunit
numbersandpriorities,ifapplicable).