Enterasys SecureStack B3

clear port priority
SecureStack B3 Configuration Guide 11-3
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetadefaultpriorityof6onge.1.3.Framesreceivedbythisport
withoutpriorityinformationintheirframeheaderaresettothedefaultsettingof6:
B3(su)->set port priority ge.1.3 6
clear port priority
UsethiscommandtoresetthecurrentCoSportprioritysettingto0.Thiswillcauseallframes
receivedwithoutapriorityvalueinitsheadertobesettopriority0.
Syntax
clear port priority port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresetge.1.11tothedefaultpriority:
B3(rw)->clear port priority ge.1.11
port‐string Specifiestheportforwhichtosetpriority.Foradetaileddescriptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”on
page 5‐1.
priority Specifiesavalueof0to7tosettheCoSpriorityfortheportenteredinthe
port‐
string.Priorityvalueof 0isthelowestpriority.
port‐string Specifiestheportforwhichtoclearpriority.Foradetaileddescriptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”on
page 5‐1.