Enterasys SecureStack B3

ping
SecureStack B3 Configuration Guide 17-15
ping
UsethiscommandtotestroutingnetworkconnectivitybysendingIPpingrequests.
Syntax
ping ip-address
Parameters
Defaults
None.
Mode
PrivilegedEXEC:B3(su)‐>router#
Usage
Thiscommandisalsoavailableinswitchmode.
Examples
ThisexampleshowsoutputfromasuccessfulpingtoIPaddress182.127.63.23:
B3(su)->router#ping 182.127.63.23
182.127.63.23 is alive
ThisexampleshowsoutputfromanunsuccessfulpingtoIPaddress182.127.63.24:
B3(su)->router#ping 182.127.63.24
no answer from 182.127.63.24
traceroute
Usethiscommandtodisplayahop‐by‐hoppaththroughanIPnetworkfromthedevicetoa
specificdestinationhost.ThreeICMPprobeswillbetransmittedforeachhopbetweenthesource
andthetraceroutedestination.
Syntax
traceroute host
Parameters
Defaults
None.
Mode
PrivilegedEXEC:B3(su)‐>router#
ip‐address SpecifiestheIPaddressofthesystemtoping.
host SpecifiesahosttowhichtherouteofanIPpacketwillbetraced.