Enterasys SecureStack B3 User Manual

show port protected name
5-50 Port Configuration
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoassignthename“group1”toprotectedportgroup1:
B3(rw)->set port protected name 1 group1
show port protected name
Usethiscommandtodisplaythenameforthegroupidsspecified.
Syntax
show port protected name group-id
Parameters
Defaults
None.
Mode
Read‐only.
Example
Thisexampleshowshowtoshowthenameofprotectedportgroup1:
B3(ro)->show port protected name 1
Group ID Group Name
-----------------------------
1 group1
clear port protected name
Usethiscommandtoclearthenameofaprotectedgroup.
Syntax
clear port protected name group-id
Parameters
Defaults
None.
group‐id Specifiestheidofthegrouptodisplay.Idcanrangefrom0to2.
group‐id Specifiestheidofthegroupforwhichtoclearthename.Idcanrange
from0to2.

Enterasys SecureStack B3 Specifications

General

Ports	24 or 48 10/100/1000BASE-T ports
Forwarding Rate	95.2 Mpps
Layer	Layer 2/3
Power Supply	Internal
Redundant Power Supply	Optional
VLANs Supported	4094
Uplink Ports	4 SFP ports
Dimensions	44.0 x 43.7 x 4.4 cm
Weight	11.9 lbs (5.4 kg)
MAC Address Table Size	16, 000 entries
Jumbo Frame Support	Up to 9, 216 bytes
Power over Ethernet	PoE+
Operating Temperature	0°C to 50°C
Storage Temperature	-20 °C to 70 °C
Humidity	10% to 95% (non-condensing)