Enterasys SecureStack B3

Configuring Simple Network Time Protocol (SNTP)
SecureStack B3 Configuration Guide 13-25
Example
Thisexampleenablesmulticastfloodprotection.
B3(su)->set mac unreserved-flood enable
Configuring Simple Network Time Protocol (SNTP)
Purpose
ToconfiguretheSimpleNetworkTimeProtocol(SNTP),whichsynchronizesdeviceclocksina
network.
Commands
show sntp
UsethiscommandtodisplaySNTPclientsettings.
Syntax
show sntp
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show sntp 13-25
set sntp client 13-27
clear sntp client 13-27
set sntp server 13-28
clear sntp server 13-28
set sntp poll-interval 13-29
clear sntp poll-interval 13-29
set sntp poll-retry 13-30
clear sntp poll-retry 13-30
set sntp poll-timeout 13-31
clear sntp poll-timeout 13-31