Enterasys SecureStack B3

set length
3-24 Basic Configuration
Example
Thisexampleshowshowtosettheterminalcolumnsto50:
B3(su)->set width 50
set length
UsethiscommandtosetthenumberoflinestheCLIwilldisplay.Thiscommandispersistent
(writtentoNV‐RAM).
Syntax
set length screenlength
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosettheterminallengthto50:
B3(su)->set length 50
show logout
Usethiscommandtodisplaythetime(inseconds)anidleconsoleorTelnetCLIsessionwill
remainconnectedbeforetimingout.
Syntax
show logout
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaytheCLIlogoutsetting:
screenlength SetsthenumberoflinesintheCLIdisplay.Validvaluesare0,which
disablesthescrollingscreenfeaturedescribedin“DisplayingScrolling
Screens”onpage1‐8,andfrom5to512.