To Next Page

To Previous Page

clear rmon event

14-14 RMON Configuration

clear rmon event

UsethiscommandtodeleteanRMONevententryandanyassociatedlogentries.

Syntax

clear rmon event index

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Example

ThisexampleshowshowtoclearRMONevent1:

B3(rw)->clear rmon event 1

Filter Group Commands

Thepacketcaptureandfilterfunctionisdisabledbydefault.Onlyoneinterfacecanbeconfigured

forcapturingandfilteringatatime.

Whenpacketcaptureisenabledonaninterface,theSecureStackB3switchwillcapture100frames

asclosetosequentiallyaspossible.These100frameswillbeplaced

intoabufferforinspection.If

thereisdatainthebufferwhenthefunctionisstarted,thebufferwillbeoverwritten.Once100

frameshavebeencaptured,thecapturewillstop.Filteringwillbeperformedontheframes

capturedinthebuffer.Therefore,onlyasubsetoftheframes

capturedwillbeavailablefor

display.

Onechannelatatimecanbesupported,withuptothreefilters.Configuredchannel,filter,and

buffercontrolinformationwillbesavedacrossresets,butcapturedframeswithinthebufferwill

notbesaved.

Thisfunctioncannotbeusedconcurrentlywithportmirroring.Thesystem

willchecktoprevent

concurrentlyenablingbothfunctions,andawarningwillbegeneratedintheCLIifattempted.

Commands

index Specifiestheindexnumberoftheentrytobecleared.

Note: Packet capture is sampling only and does not guarantee receipt of back to back packets.

For information about... Refer to page...

show rmon channel 14-15

set rmon channel 14-15

clear rmon channel 14-16

Enterasys SecureStack B3 User Manual

Questions and Answers: