Enterasys SecureStack B3

reset
SecureStack B3 Configuration Guide 3-51
reset
Usethiscommandtoresettheswitchwithoutlosinganyuser‐definedconfigurationsettings.
Syntax
reset [unit]
Parameters
Defaults
IfnounitIDisspecified,theentiresystemwillbereset.
Mode
Switchcommand,read‐write.
Usage
ASecureStackB3switchcanalsoberesetwiththeRESETbuttonlocatedonitsfrontpanel.For
informationonhowtodothis,refertotheSecureStackB3InstallationGuideshippedwithyour
switch.
Examples
Thisexampleshowshowtoresetthesystem:
B3(su)->reset
Are you sure you want to reload the stack? (y/n) y
Saving Configuration to stacking members
Reloading all switches.
Thisexampleshowshowtoresetunit1:
B3(su)->reset 1
Are you sure you want to reload the switch? (y/n) y
Reloading switch 1.
This switch is manager of the stack.
STACK: detach 3 units
clear config
Usethiscommandtocleartheuser‐definedconfigurationparam eters.
Syntax
clear config [all]
clear config 3-51
For information about... Refer to page...
unit (Optional)Specifiesaunittobereset.