Enterasys SecureStack B3

set diffserv class match
SecureStack B3 Configuration Guide 9-5
Mode
Switchcommand,read‐write.
Usage
Youcannotusethiscommandtodeleteaclassthathasbeenassignedtoapolicy.Beforedeletinga
classwithanassignedpolicyandserviceport(s),youmustfirst:
•Removetheserviceport(s)assignedtothepolicyusingthesetdiffservserviceremove
command(page 9‐16),then
•Removethespecified
classusingthesetdiffservpolicyclassremovecommand(page 9‐11).
Example
ThisexampleshowshowtodeletetheDiffserv“admin”class:
B3(rw)->set diffserv class delete admin
set diffserv class match
UsethiscommandtomatchaDiffservclasstoaserviceconditionbasedonlayer2,3,and4packet
parameters.
set diffserv class match {[every classname] [dstmac | scrmac classname macaddr
macmask] [dstip | srcip classname ipaddr ipmask] [dstl4port | srcl4port{keyword
classname keyword | number classname portnumber}] [ipdscp classname dscpval]
[ipprecedence classname precedencenumber] [iptos classname tosbits tosmask]
[protocol {keyword classname protocol-name | number classname protocol-number}]
[refclass {add | remove}{classname refclassname}] [vlan classname vlanid]}
Parameters
everyclassname Matchesallpacketstoaspecificclass.
dstmac|scrmacclassname
macaddrmacmask
MatchestoaspecificclassbasedondestinationorsourceMAC
address.
dstip|srcipclassname
ipaddripmask
MatchestoaspecificclassbasedondestinationorsourceIP
address.