Enterasys SecureStack B3

set spantree mstmap
7-14 Spanning Tree Configuration
set spantree mstmap
UsethiscommandtomaponeormorefilteringdatabaseIDs(FIDs)toaSID.SinceVLANsare
mappedtoFIDs,thisessentiallymapsoneormoreVLANIDstoaSpanningTree(S ID).
Syntax
set spantree mstmap fid [sid sid]
Parameters
Defaults
Ifsidisnotspecified,FID(s)willbemappedtoSpanningTree0.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtomapFID3toSID2:
B3(su)->set spantree mstmap 3 sid 2
clear spantree mstmap
UsethiscommandtomapaFIDbacktoSID0.
Syntax
clear spantree mstmap fid
Parameters
Defaults
Iffidisnotspecified ,allSIDtoFIDmappingswillbereset.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtomapFID2backtoSID 0:
B3(su)->clear spantree mstmap 2
fid SpecifiesoneormoreFIDstoassigntotheMST.Validvaluesare1‐4093,
andmustcorrespondtoaVLANIDcreatedusingthesetvlancommand.
sidsid (Optional)SpecifiesaMultipleSpanningTreeID.Validvaluesare1‐4094,
andmustcorrespondtoaSIDcreated
usingthesetmsticommand.
fid SpecifiesoneormoreFIDstoresetto0.