Enterasys SecureStack B3

show tftp settings
SecureStack B3 Configuration Guide 3-47
show tftp settings
UsethiscommandtodisplayTFTPsettingsusedbytheswitchduringdatatransfersusingTFTP. 
Syntax
show tftp settings
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Usage
TheTFTPtimeoutvaluecanbesetwiththesettftptimeo utcommand.TheTFTPretryvaluecan
besetwiththesettftpretrycommand.
Example
Thisexampleshowstheoutputofthiscommand.
B3(ro)->show tftp settings
TFTP packet timeout (seconds): 2
TFTP max retry: 5
set tftp timeout
UsethiscommandtoconfigurehowlongTFTPwillwaitforareplyofeitheranacknowledgement
packetoradatapacketduringadatatransfer.
Syntax
set tftp timeout seconds
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplesetsthetimeoutperiodto4seconds.
B3(rw)->set tftp timeout 4
seconds Specifiesthenumberofsecondstowaitforareply.Thevalidrangeis
from1to30seconds.Defaultvalueis2seconds.