Enterasys SecureStack B3

ping
SecureStack B3 Configuration Guide 13-13
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetthesizeofthecommandhistorybufferto30lines:
B3(su)->set history 30
ping
UsethiscommandtosendICMPecho‐requestpacketstoanothernodeonthenetworkfromthe
switchCLI.
Syntax
ping host
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Examples
ThisexampleshowshowtopingIPaddress134.141.89.29.Inthiscase,thishostisalive:
B3(su)->ping 134.141.89.29
134.141.89.29 is alive
Inthisexample,thehostatIPaddressisnotresponding:
B3(su)->ping 134.141.89.255
no answer from 134.141.89.255
show users
UsethiscommandtodisplayinformationabouttheactiveconsoleportorTelnetsession(s)logged
intotheswitch.
size Specifiesthesizeofthehistorybufferinlines.Validvaluesare1to100.
default (Optional)Makesthissettingpersistentforallfuturesessions.
host SpecifiestheIPaddressofthedevicetowhichthepingwillbesent.