Enterasys SecureStack B3 User Manual

SecureStack B3 Configuration Guide 10-1
10
Policy Classification Configuration
ThischapterdescribesthePolicyClassificationsetofcommandsandhowtousethem.
Policy Classification Configuration Summary
SecureStackB3devicessupportpolicyprofile‐basedprovisioningofnetworkresourcesby
allowingITadministratorsto:
•Create,changeorremovepolicyprofilesbasedonbusiness‐specificuseofnetworkservices.
•Permitordenyaccesstospecificservicesbycreatingandassigningclassificationruleswhich
mapuserprofilestoprotocol‐basedframefiltering
policiesconfiguredforaparticularVLAN
orClassofService(CoS).
• Assignorunassignportstopolicyprofilessothatonlyportsactivatedforaprofilewillbe
allowedtotransmitframesaccordingly.
Configuring Policy Profiles
Purpose
Toreview,create,changeandremoveuserprofilesthatrelatetobusiness‐drivenpoliciesfor
managingnetworkresources.
Note: A license is required to enable Policy on the SecureStack B2 and B3. Refer to “Activating
Licensed Features” on page 3-26 for more information.
For information about... Refer to page...
Policy Classification Configuration Summary 10-1
Configuring Policy Profiles 10-1
Configuring Classification Rules 10-5
Assigning Ports to Policy Profiles 10-14
Configuring Policy Class of Service (CoS) 10-16
Note: It is recommended that you use Enterasys Networks NetSight Policy Manager as an
alternative to CLI for configuring policy classification on the SecureStack B3 devices.

Enterasys SecureStack B3 Specifications

General

Brand	Enterasys
Model	SecureStack B3
Category	Switch
Language	English