To Next Page

To Previous Page

Reviewing IP Traffic and Configuring Routes

SecureStack B3 Configuration Guide 17-13

Example

ThisexampleshowhowtohaveallclientDHCPrequestsforusersinVLAN1tobeforwardedto

theremoteDHCPserverwithIPaddress192.168.1.28.

B3(su)->router(Config)#interface vlan 1

B3(su)->router(Config-if(Vlan 1))#ip helper-address 192.168.1.28

Reviewing IP Traffic and Configuring Routes

Purpose

ToreviewIPtrafficandconfigureroutes,tosendrouterICMP (ping)messages,andtoexecute

traceroute.

Commands

show ip route

UsethiscommandtodisplayinformationaboutIProutes.

Syntax

show ip route [connected | rip | static | summary]

Parameters

Defaults

Ifnoparametersarespecified,allIProuteinformationwillbedisplayed.

Mode

Anyroutermode.

For information about... Refer to page...

show ip route 17-13

ip route 17-14

ping 17-15

traceroute 17-15

connected (Optional)Displaysconnectedroutes.

rip (Optional)DisplaysroutesconfiguredfortheRIProutingprotocol.For

detailsonconfiguringRIP,referto“ConfiguringRIP”onpage 18‐1.

static (Optional)Displaysstaticroutes.

summary (Optional)DisplaysasummaryoftheIProutingtable.

Enterasys SecureStack B3 User Manual

Questions and Answers: