Enterasys SecureStack B3

clear dhcp pool client-name
15-18 DHCP Server Configuration
Mode
Switchcommand,read‐write.
Example
Thisexampleconfigurestheclientname“appsvr1”tothemanualbindingpool“manual2.”
B3(rw)->set dhcp pool manual2 client-identifier 01:22:33:44:55:66
B3(rw)->set dhcp pool manual2 host 10.12.1.10 255.255.255.0
B3(rw)->set dhcp pool manual2 client-name appsvr1
clear dhcp pool client-name
UsethiscommandtodeleteaDHCPclientnamefromanaddresspoolformanualbinding.
Syntax
clear dhcp pool poolname client-name
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampledeletestheclientnamefromthemanualbindingpool“manual2.”
B3(rw)->clear dhcp pool manual2 client-name
set dhcp pool bootfile
UsethiscommandtospecifyadefaultbootimagefortheDHCPclientswhowillbeservedbythe
addresspoolbeingconfigured.
Syntax
set dhcp pool poolname bootfile filename
Parameters
Defaults
None.
poolname Specif iesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
poolname Specif iesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
filename Specifiesthebootimagefilename.