Enterasys SecureStack B3

show webview
SecureStack B3 Configuration Guide 3-53
Commands
show webview
UsethiscommandtodisplayWebViewstatus.
Syntax
show webview
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayWebViewstatus:
B3(rw)->show webview
WebView is Enabled.
set webview
UsethiscommandtoenableordisableWebViewonthesw itch.
Syntax
set webview {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
For information about... Refer to page...
show webview 3-53
set webview 3-53
show ssl 3-54
set ssl 3-54
enable|disable EnableordisableWebViewontheswitch.