Enterasys SecureStack B3 - Set Pwa Quietperiod; Set Pwa Maxrequest

set pwa quietperiod
20-66 Security Configuration
set pwa quietperiod
Usethiscommandtosettheamountoftimeaportwillremainintheheldstateafterauser
unsuccessfullyattemptstologontothenetwork.
Syntax
set pwa quietperiod time [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,quietperiodwillbesetforallports.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetthePWAquietperiodto30secondsforportsge.1.5‐7:
B3(su)->set pwa quietperiod 30 ge.1.5-7
set pwa maxrequest
Usethiscommandtosetthemaximumnumberoflogonattemptsallowedbeforetransitioning
thePWAporttoaheldstate.
Syntax
set pwa maxrequests requests [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,maximumrequestswillbesetforallports.
Mode
Switchcommand,read‐write.
time Specifiesquiettimeinseconds.
port‐string (Optional)Setsthequietperiodforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 5 ‐1.
maxrequests Specifiesthemaximumnumberoflogonattempts.
port‐string (Optional)Setsthemaximumrequestsforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 5 ‐1.