Enterasys SecureStack B3

Configuring Secure Shell (SSH)
SecureStack B3 Configuration Guide 20-69
Example
ThisexampleshowshowtoenablePWAenhancedmode:
B3(su)->set pwa enhancedmode enable
Configuring Secure Shell (SSH)
Purpose
Toreview,enable,disable,andconfiguretheSecureShell(SSH)protocol,whichprovidessecure
Telnet.
Commands
show ssh status
UsethiscommandtodisplaythecurrentstatusofSSHontheswitch.
Syntax
show ssh status
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaySSHstatusonthesw itch:
B3(su)->show ssh status
SSH Server status: Disabled
set ssh
Usethiscommandtoenable,disableorreinitializeSSHserverontheswitch.Bydefault,theSSH
serverisdisabled.
For information about... Refer to page...
show ssh status 20-69
set ssh 20-69
set ssh hostkey 20-70