Enterasys SecureStack B3 User Manual

clear dhcp pool dns-server
SecureStack B3 Configuration Guide 15-23
Syntax
set dhcp pool poolname dns-server address [address2 ... address8]
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleassignsaDNSserverat10.14.10.1totheaddresspool“‘auto1.”
B3(rw)->set dhcp pool auto1 dns-server 10.14.10.1
clear dhcp pool dns-server
UsethiscommandtoremovetheDNSserverlistfromtheaddresspoolbeingconfigured.
Syntax
clear dhcp pool poolname dns-server
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleremovestheDNSserverlistfromtheaddresspool“auto1.”
B3(rw)->clear dhcp pool auto1 dns-server
set dhcp pool domain-name
UsethiscommandtospecifyadomainnametobeassignedtoDHCPclientsservedbythe
addresspoolbeingconfigured.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
address SpecifiestheIPaddressofaDNSserver.
address2...address8 (Optional)Specifies,
inorderofpreference,upto7additionalDNS
serveraddresses.
poolname Specif iesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.

Enterasys SecureStack B3 Specifications

General

Brand	Enterasys
Model	SecureStack B3
Category	Switch
Language	English