Enterasys SecureStack B3

set cos state
SecureStack B3 Configuration Guide 10-19
set cos state
UsethiscommandtoenableordisableClassofService.
Syntax
set cos state {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoenableClassofService:
B3(rw)->set cos state enable
show cos state
UsethiscommandtodisplaytheClassofServiceenablestate.
Syntax
show cos state
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtoshowtheClassofServiceenablestate:
B3(rw)->show cos state
Class-of-Service application is enabled
clear cos state
UsethiscommandtosetCoSstatebacktoitsdefaultsettingofdisabled.
enable|disable EnablesordisablesClassofServiceontheswitch.Defaultstateis
disabled.