Enterasys SecureStack B3

set port trap
SecureStack B3 Configuration Guide 5-19
Parameters
Defaults
Ifport‐stringisnotspecified,thetrapstatusforallportswillbedisplayed.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtodisplaylinktrapstatusforge.3.1through4:
B3(su)->show port trap ge.3.1-4
Link traps enabled on port ge.3.1.
Link traps enabled on port ge.3.2.
Link traps enabled on port ge.3.3.
Link traps enabled on port ge.3.4.
set port trap
UsethiscommandtoenableofdisableportsforsendingSNMPtrapmessageswhentheirlink
statuschanges.
Syntax
set port trap port-string {enable | disable}
Parameters
Defaults
Sendingtrapswhenlinkstatuschangesisenabledbydefault.
Mode
Switchcommand,read‐write.
Example
Thefollowingexampledisablessendingtraponge.3.1.
B3(su)->set port trap ge.3.1 disable
port‐string (Optional)Displayslinktrapstatusforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage5‐1.
port‐string Specifiestheport(s)forwhichtoenableordisableporttraps.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage5‐1.
enable|disable Enablesordisablessendingtrapmessageswhenlinkstatuschanges.