Enterasys SecureStack B3

SecureStack B3 Configuration Guide 4-1
4
Discovery Protocol Configuration
Thischapterdescribeshowtoconfigurediscoveryprotocols.
Configuring CDP
Purpose
ToreviewandconfiguretheEnterasysCDPdiscoveryprotocol.Thisprotocolisusedtodiscover
networktopology.Whenenabled,thisprotocolallowsEnterasysdevicestosendperiodicPDUs
aboutthemselvestoneighboringdevices.
Commands
ThecommandsusedtoreviewandconfiguretheCDPdiscoveryprotocolarelistedbelow.
show cdp
UsethiscommandtodisplaythestatusoftheCDPdiscoveryprotocolandmessageintervalon
oneormoreports.
For information about... Refer to page...
Configuring CDP 4-1
Configuring Cisco Discovery Protocol 4-6
Configuring Link Layer Discovery Protocol and LLDP-MED 4-13
For information about... Refer to page...
show cdp 4-1
set cdp state 4-3
set cdp auth 4-3
set cdp interval 4-4
set cdp hold-time 4-5
clear cdp 4-5
show neighbors 4-6