Enterasys SecureStack B3

show snmp persistmode
SecureStack B3 Configuration Guide 3-41
show snmp persistmode
Usethiscommandtodisplaytheconfigurationpersistencemodesetting.
Syntax
show snmp persistmode
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Usage
Bydefault,themodeissetto“autosave,”whichautomaticallysavesconfigurationchangesat
specificintervals.Ifthemodeissetto“manua l,” configurationcommandsareneverautomatically
saved.Inordertomakeconfigurationchangespersistentwhenthemodeismanual,thesave
configcommandmustbeissuedasdescribed
in“Configuration PersistenceMode”onpage3‐40.
Example
Thisexampleshowshowtodisplaytheconfigurationpersistencemodesetting.Inthiscase,
persistencemodeissetto“manual”,whichmeansconfigurationchangesarenotbeing
automaticallysaved.
B3(su)->show snmp persistmode
persistmode is manual
set snmp persistmode
Usethiscommandtosettheconfigurationpersistencemode,whichdetermineswhetheruser‐
definedconfigurationchangesaresavedautomatically,orrequireissuingthesaveconfig
command.See“ConfigurationPersistenceMode”onpage3‐40formoreinformation.
Syntax
set snmp persistmode {auto | manual}
Parameters
auto Setstheconfigurationpersistencemodetoautomatic.Thisisthedefault
state.
manual Setstheconfigurationpersistencemodetomanual.Inordertomake
configurationchangespersistent,thesaveconfigcommandmustbe
issuedasdescribedin“saveconfig”onpage3‐42.Thismodeisusefulfor
revertingback
tooldconfigurations.