Enterasys SecureStack B3

set port broadcast
5-28 Port Configuration
Parameters
Defaults
Ifport‐stringisnotspecified,broadcaststatusofallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythebroadcastsuppressionthresholdsforports1through4:
B3(su)->show port broadcast ge.1.1-4
Port Total BC Threshold
Packets (pkts/s)
----------------------------------------
ge.1.1 0 50
ge.1.2 0 50
ge.1.3 0 40
ge.1.4 0 14881
set port broadcast
Usethiscommandtosetthebroadcastsuppressionthreshold,inpacketspersecond,ononeor
moreports.Thissetsathresholdonthebroadcasttrafficthatisreceivedandswitchedouttoother
ports.
Syntax
set port broadcast port-string threshold-val
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleconfiguresports1through5withabroadcastlimitof50pps:
B3(su)->set port broadcast ge.1.1-5 50
port‐string (Optional)Selecttheportsforwhichtoshowbroadcastsuppression
thresholds.Foradetaileddescriptionofpossibleport‐stringvalues,refer
to“PortSt ringSyntaxUsedintheCLI”onpage5‐1.
port‐string Selecttheportsforwhichtoconfigurebroadcastsuppressionthresholds.
Foradetaileddescriptionofpossibleport‐stringvalues,referto“Port
StringSyntaxUsedintheCLI”onpage5‐1.
threshold‐val Setsthepacketspersecondthresholdonbroadcasttraffic.Maximum
valueis1488 10forFast
Ethernetportsand1488100forGigabitports.