Enterasys SecureStack B3

clear dhcp pool client-identifier
SecureStack B3 Configuration Guide 15-17
Example
Thisexampleshowshowtoconfiguretheminimumrequirementsforamanualbindingaddress
pool,usingaclientidentifierratherthanthehardwareaddressoftheclient’shardwareplatform.
B3(rw)->set dhcp pool manual2 client-identifier 01:00:01:22:33:44:55
B3(rw)->set dhcp pool manual2 host 10.12.1.10 255.255.255.0
clear dhcp pool client-identifier
UsethiscommandtoremovetheuniqueidentifierofaDHCPclientfromamanualbinding
addresspool.
Syntax
clear dhcp pool poolname client-identifier
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampledeletestheclientidentifierfromtheaddresspoolnamed“manual1.”
B3(rw)->clear dhcp pool manual1 client-identifier
set dhcp pool client-name
UsethiscommandtoassignanametoaDHCPclientwhencreatinganaddresspoolformanual
binding.
Syntax
set dhcp pool poolname client-name name
Parameters
Defaults
None.
poolname Specif iesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
poolname Specif iesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
name Specifiesthenametobeassignedtothisclient.Clientnamesmaybeupto
31charactersinlength.