Enterasys SecureStack B3

Configuring Diffserv Policies and Assigning Classes
SecureStack B3 Configuration Guide 9-9
Configuring Diffserv Policies and Assigning Classes
Purpose
Toreview,create,andconfigureDiffservpoliciesandassignclasses.
Commands
Thecommandsusedtoreview,create,andconfigureDiffservpoliciesandassignclassesarelisted
belowanddescribedintheassociatedsectionasshown.
show diffserv policy
UsethiscommandtodisplayinformationaboutDiffservpolicies.
Syntax
show diffserv policy {summary | detailed policyname}
Parameters
Defaults
None.
Mode
Switchcommand.Read‐Only.
For information about... Refer to page...
show diffserv policy 9-9
set diffserv policy create 9-10
set diffserv policy delete 9-10
set diffserv policy class 9-11
set diffserv policy mark 9-11
set diffserv policy police style simple 9-12
set diffserv policy police action conform 9-13
set diffserv policy police action nonconform 9-13
set diffserv policy rename 9-14
summary DisplaysDiffservpolicysummaryinformation.
detailed
policyname
DisplaysdetailedDiffservinformationforaspecificpolicy.