Enterasys SecureStack B3

set rmon event status
SecureStack B3 Configuration Guide 14-13
Defaults
Ifdescriptionisnotspecified,nonewillbeapplied.
Ifnotspecified,typenonewillbeapplied.
Ifownerisnotspecified,monitorwillbeapplied.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocreateandenableanRMONevententrycalled“STPtopology
change”thatwillsendbothalogentryandanSNMPtrapmessagetothe“public”community:
B3(rw)->set rmon event properties 2 description "STP topology change" type both
community public owner Manager
set rmon event status
UsethiscommandtoenableanRMONevententry.Anevententrydescribestheparametersofan
RMONeventthatcanbetri ggered.EventscanbefiredbyRMONalarmsandcanbeconfiguredto
createalogentry, generateatrap,orboth.
Syntax
set rmon event status index enable
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
AnRMONevententrycanbecreatedusing thiscommand,configuredusingthesetrmonevent
propertiescommand(“setrmoneventproperties”onpage 14‐12),thenenabledusingthis
command.AnRMONevententrycanbecreatedandconfiguredatthesametimebyspecifyingan
unusedindexwiththe
setrmoneventpropertiescommand.
Example
ThisexampleshowshowtoenableRMONevententry1:
B3(rw)->set rmon event status 1 enable
ownerowner (Optional)Specif iesthenameoftheentitythatconfiguredthisentry.
index Specifiesanindexnumberforthisentry.Maximumnumberofentriesis
100.Maximumvalueis65535.
enable Enablesthisevententry.