Enterasys SecureStack B3 User Manual

set rmon event properties
14-12 RMON Configuration
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayRMONevententry3:
B3(rw)->show rmon event 3
Index 3
----------------
Owner = Manager
Status = valid
Description = STP Topology change
Type = log-and-trap
Community = public
Last Time Sent = 0 days 0 hours 0 minutes 37 seconds
Table 14‐3providesanexplanationofthecommandoutput.
set rmon event properties
UsethiscommandtoconfigureanRMONevententry,ortocreateanewevententrywithan
unusedeventindexnumber.
Syntax
set rmon event properties index [description description] [type {none | log | trap
| both}] [community community] [owner owner]
Parameters
Table 14-3 show rmon event Output Details
Output What It Displays...
Index Index number for this event entry.
Owner Text string identifying who configured this entry.
Status Whether this event entry is enabled (valid) or disabled.
Description Text string description of this event.
Type Whether the event notification will be a log entry, and SNMP trap, both, or none.
Community SNMP community name if message type is set to trap.
Last Time Sent When an event notification matching this entry was sent.
index Specifiesanindexnumberforthisentry.Maximumnumberofentriesis
100.Maximumvalueis65535.
description
description
(Optional)Specifiesatextstringdescriptionofthisevent.
typenone|log|
trap|both
(Optional)SpecifiesthetypeofRMONeventnotificationas:none,alog
tableentry,anSNMP
trap,orbothalogentryandatrapmessage.
community
community
(Optional)SpecifiesanSNMPcommunitynametouseifthemessage
typeissettotrap.FordetailsonsettingSNMPtrapsandcommunity
names,referto“CreatingaBasicSNMPTrapConfiguration”on
page 6‐36.

Enterasys SecureStack B3 Specifications

General

Brand	Enterasys
Model	SecureStack B3
Category	Switch
Language	English