Enterasys SecureStack B3

show multiauth idle-timeout
SecureStack B3 Configuration Guide 20-37
Parameters
Defaults
Ifnooptionsarespecified,multipleauthenticationsessionentrieswillbedisplayedforall
sessions,authenticationtypes,MACaddresses,andports.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaymultipleau thenticationsessioninformationforportge.1.1.
B3(su)->show multiauth session port ge.1.1
__________________________________________
Port | ge.1.1 Station address | 00-01-03-86-0A-87
Auth status | success Last attempt | FRI MAY 18 11:16:36 2007
Agent type | dot1x Session applied | true
Server type | radius VLAN-Tunnel-Attr | none
Policy index | 0 Policy name | Administrator
Session timeout | 0 Session duration | 0,00:00:25
Idle timeout | 5 Idle time | 0,00:00:00
Termination time | Not Terminated
show multiauth idle-timeout
Usethiscommandtodisplaythetimeoutvalue,inseconds,foranidlesessionforall
authenticationmethods.
Syntax
show multiauth idle-timeout
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
all (Optional)Displaysinformationaboutallsessions,includingthosewith
terminatedstatus.
agentdot1x|mac|
pwa
(Optional)Displays802.1X,orMAC,orportwebauthenticationsession
information.
macaddress (Optional)Displaysmultipleauthenticationsessionentriesforspecific
MACaddress(es).
portport‐string (Optional)Displaysmultipleauthenticationsessionentriesfor
the
specifiedportorports.