Enterasys SecureStack B3 - Show Eapol Output Details

show eapol
20-16 Security Configuration
Syntax
show eapol [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,onlyEAPOLenablestatuswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayEAPOLstatusforportsge.1.1‐3:
B3(su)->show eapol ge.1.1-3
EAPOL is disabled.
Port Authentication State Authentication Mode
-------- -------------------- --------------------
ge.1.1 Initialize Auto
ge.1.2 Initialize Auto
ge.1.3 Initialize Auto
Table 20‐2providesanexplanationofthecommandoutput.Fordetailsonusingtheseteapol
commandtoenabletheprotocolandassignanauthenticationmode,referto“seteapol”on
page 20‐17.
port‐string (Optional)DisplaysEAPOLstatusforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,
referto“PortStringSyntaxUsed
intheCLI”onpage 5 ‐1.
Table 20-2 show eapol Output Details
Output What It Displays...
Port Port designation. For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 5-1.