Enterasys SecureStack B3

show cos unit
10-30 Policy Classification Configuration
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocleartheCoSinboundratelimitingreferenceconfigurationforall
groups:
B3(su)->clear cos reference irl all
show cos unit
UsethiscommandtoshowpossibleCoSunitentries.
Syntax
show cos unit
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowspossibleunitentriesforinboundratelimiting:
B3(su)->show cos unit
Type: Unit:
irl = inbound rate limiting Kbps = Kilobits per second
Port Type Type Unit Maximum Rate Minimum Rate Granularity
--------- ---- ---- ------------ ------------ -----------
0 irl Kbps 1000000 512 1
irl SpecifiesthatIRLreferencesarebeingcleared.
all Clearallgroupsindexesandreferences.
group‐type‐index Specifiesaninboundratelimitingportgroup/typeindex.Validentries
areintheformofgroup#.port‐type.
Validvaluesforgroup#canrangefrom0to7.Validvaluesforport‐type
canrange
from0to1,althoughonlyporttype0iscurrentlysupported.
Forexample,portgroup3wouldbespecifiedas3.0.
reference Clearaspecificreferenceforthespecifiedportgroup.