Enterasys SecureStack B3

set diffserv policy create
9-10 Differentiated Services Configuration
Example
ThisexampleshowshowtodisplayasummaryofDiffservpolicyinformation.Inthiscase,there
isonepolicynamed“admin”,towhichmembersofthe“admin”classhavebeenassigned.This
policyisappliedtoincomingtrafficonitsassignedserviceports:
B3(rw)->show diffserv policy summary
Policy Name Policy Type Class Members
-------------------- ----------- -------------------------------
admin In admin
set diffserv policy create
UsethiscommandtocreateanewDiffservpolicy.
Syntax
set diffserv policy create policyname {in}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocreateaDiffservpolicycalled“admin”andapplyittoincoming
packets:
B3(rw)->set diffserv policy create admin in
set diffserv policy delete
UsethiscommandtodeleteaDiffservpolicy.
Syntax
set diffserv policy delete policyname
Parameters
Defaults
None.
policyname Specifiesapolicyname.
in Appliesthispolicytoincomingpackets.
policyname Specifiesapolicynametobedeleted.