Enterasys SecureStack B3

Using the Command Line Interface
1-8 Introduction
Writeaccesswillbeabletomodifyallmodifiableparametersinsetandshowcommands,aswell
asviewRead‐Onlycommands.AdministratorsorSuperUserswillbeallowedallRead‐Writeand
Read‐Onlyprivileges,andwillbeabletomodifylocaluseraccounts.TheSecureStackB3switch
indicateswhich
modeauserisloggedinasbydisplayingoneofthefollow ingprompts:
•Admin:B3(su)‐>
•Read‐Write:B3(rw)‐>
•Read‐Only:B3(ro)‐>
Performing Keyword Lookups
Enteringaspaceandaquestionmark(?)afterakeywordwilldisplayallcommandsbeginning
withthekeyword.Figure 1‐3showshowtoperformakeywordlookupfortheshowsnmp
command.Inthiscase,fouradditionalkeywordsareusedbytheshowsnmpcommand.Entering
aspaceand
aquestionmark(?)afteranyoftheseparameters(suchasshowsnmpcommunity)
willdisplayadditionalparametersnestedwithinthesyntax.
Figure 1-3 Performing a Keyword Lookup
Enteringaquestionmark(?)withoutaspaceafterapartialkeywordwilldisplayalistof
commandsthatbeginwiththepartialkeyword.Figure 1‐4shows
howtouse thisfunctionforall
commandsbeginningwithco:
Figure 1-4 Performing a Partial Keyword Lookup
Displaying Scrolling Screens
IftheCLIscreenlengthhasbeensetusingthesetlengthcommandasdescribedonpage3‐24,CLI
outputrequiringmorethanonescreenwilldisplay--More-- toindicatecontinuingscreens.To
displayadditionalscreenoutput:
•PressanykeyotherthanENTERtoadvancetheoutputonescreenat
atime.
•PressENTERtoadvancetheoutputonelineatatime.
TheexampleinFigure 1‐5showshowtheshowmaccommandindicatesthatoutputcontinueson
morethanonescreen.
B3(su)->show snmp ?
community SNMP v1/v2c community name configuration
notify SNMP notify configuration
targetaddr SNMP target address configuration
targetparams SNMP target parameters configuration
B3(rw)->co?
configure copy
B3(su)->co
Note: At the end of the lookup display, the system will repeat the command you entered without the
?.