Enterasys SecureStack B3

clear spantree lpthreshold
7-46 Spanning Tree Configuration
Example
ThisexampleshowshowtodisplaythecurrentLoopProtectthresholdvalue:
B3(rw)->show spantree lpthreshold
The Loop Protect event threshold value is 4
clear spantree lpthreshold
UsethiscommandtoreturntheLoopProtecteventthresholdtoitsdefaultvalueof3.
Syntax
clear spantree lpthreshold
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoresettheLoopProtecteventthresholdtothedefaultof3:
B3(rw)->clear spantree lpthreshold
set spantree lpwindow
UsethiscommandtosettheLoopProtecteventwindowvalueinseconds.
Syntax
set spantree lpwindow value
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
TheLoopProtectWindowisatimervalue,inseconds,thatdefinesaperiodduringwhichLoop
Protecteventsarecounted.Thedefaultvalueis180seconds.Iftheti merissetto0,theevent
value Specifiesthenumberofsecondsthatcomprisetheperiodduringwhich
LoopProtectevents
arecounted.Thedefaulteventwindowis180
seconds.