Enterasys SecureStack B3

clear mirror vlan
SecureStack B3 Configuration Guide 5-33
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Referto“RemotePortMirroring”onpage5‐30forinformationaboutconfiguringmirrorVLANs.
UsetheshowportmirroringcommandtodisplaytheVLANsconfiguredforremoteport
mirroring.
Example
ThefollowingexampleassignsaVLANformirroringtrafficandthenshowstheconfiguredport
mirroringwiththeshowportmirrorcommand.
B3(su)->set mirror vlan 2
B3(su)->show port mirroring
Port Mirroring
==============
Source Port = ge.1.1
Target Port = ge.1.10
Frames Mirrored = Rx and Tx
Port Mirroring status enabled
Mirror Vlan = 2
clear mirror vlan
UsethiscommandtocleartheVLANtobereservedformirroringtraffic.
Syntax
clear mirror vlan vlan-id
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
vlan‐id SpecifiestheVLANtobeusedforremoteportmirroring.TheIDcan
rangefrom2to4093.
vlan‐id SpecifiestheVLANtobecleared.TheIDcanrangefrom2to4093.