Enterasys SecureStack B3

Configuring Power over Ethernet (PoE)
SecureStack B3 Configuration Guide 3-31
Configuring Power over Ethernet (PoE)
Purpose
ToreviewandsetPoEparam eters,includingthepoweravailabletothesystem,theusage
thresholdforeachmodule,whetherornotSNMPtrapmessageswillbesentwhenpowerstatus
changes,andper‐portPoEsettings.
Commands
ThecommandsusedtoreviewandsetPoEportparametersarelistedbelow.
show inlinepower
UsethiscommandtodisplayswitchPoEproperties.
Syntax
show inlinepower
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Important Notice
This section applies only to PoE-equipped SecureStack B3 devices. Consult the Installation Guide shipped
with your product to determine if it is PoE-equipped.
For information about... Refer to page...
show inlinepower 3-31
set inlinepower threshold 3-32
set inlinepower trap 3-32
show port inlinepower 3-33
set port inlinepower 3-33