Enterasys SecureStack B3 - Show Spantree Portadmin; Show Spantree Portpri

show spantree portadmin
SecureStack B3 Configuration Guide 7-33
Syntax
clear spantree portadmin port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoresetthedefaultSpanningTreeadminstatetoenableonge.1.12:
B3(rw)->clear spantree portadmin ge.1.12
show spantree portadmin
UsethiscommandtodisplaythestatusoftheSpanningTreealgorithmononeormoreports.
Syntax
show spantree portadmin [port port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,statuswillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplayportadminstatusforge.1.1:
B3(ro)->show spantree portadmin port ge.1.1
Port ge.1.1 has portadmin set to enabled
show spantree portpri
UsethiscommandtoshowtheSpanningTreepriorityforoneormoreports.Portpriorityisa
componentoftheportID,whichisoneelementusedindeterminingSpanningTreeportroles.
port‐string Resetsthedefaultadminstatusonspecificport(s).Foradetailed
descriptionofpossibleport‐string
values,referto“PortStringSyntaxUsed
intheCLI”onpage 5 ‐1.
portport‐string (Optional)Displaysstatusforspecificport(s).Foradetaileddescriptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”
onpage 5‐1.