Enterasys SecureStack B3 User Manual (English)

To Next Page

To Previous Page

show spantree mstilist

7-12 Spanning Tree Configuration

show spantree mstilist

UsethiscommandtodisplayalistofMultipleSpanningTree(MST)instancesconfiguredonthe

device.

Syntax

show spantree mstilist

Parameters

None.

Defaults

None.

Mode

Switchcommand,read‐only.

Example

ThisexampleshowshowtodisplayalistofMSTinstances.Inthiscase,SID2hasbeenconfigured:

B3(su)->show spantree mstilist

Configured Multiple Spanning Tree instances:

set spantree msti

UsethiscommandtocreateordeleteaMultipleSpanningTreeinstance.

Syntax

set spantree msti sid sid {create | delete}

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Example

ThisexampleshowshowtocreateanMSTinstance2:

B3(su)->set spantree msti sid 2 create

sidsid SetstheMultipleSpanningTreeID.Validvaluesare1‐4094.

SecureStackB3deviceswillsupportupto4MSTinstances.

create|delete CreatesordeletesanMSTinstance.

Need help?

Do you have a question about the Enterasys SecureStack B3 and is the answer not in the manual?

Enterasys SecureStack B3 Specifications

General