Enterasys SecureStack B3

clear summertime
3-18 Basic Configuration
Syntax
set summertime recurring start_week start_day start_month start_hr_min end_week
end_day end_month end_hr_min [offset_minutes]
Parameters
Defaults
Ifanoffsetisnotspecified,nonewillbeapplied.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowsetdaylightsavingstimetorecurstartingonthefirstSundayofAprilat
2a.m.andendingthelastSundayofOctoberat2a.m.withanoffsettimeofonehour:
B3(su)->set summertime recurring first Sunday April 02:00 last Sunday October
02:00 60
clear summertime
Usethiscommandtoclearthedaylightsavingstimeconfiguration.
Syntax
clear summertime
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
start_week Specifiestheweekofthemonthtorestartdaylightsavingstime.Valid
valuesare:first,second,third,fourth,andlast.
start_day Specifiesthedayoftheweektorestartdaylightsavingstime.
start_hr_min Specifiesthetimeofdaytorestartdaylightsavingstime.Forma tis
hh:mm.
end_week Specifies
theweekofthemonthtoenddaylightsavingstime.
end_day Specifiesthedayoftheweektoenddaylightsavingstime.
end_hr_min Specifiesthetimeofdaytoenddaylightsavingstime.Formatishh:mm.
offset_minutes (Optional)Specifiestheamountoftimeinminutestooffsetdaylight
savingstimefromthenon‐
daylightsavingstimesystemsetting.Valid
valuesare1‐1440.