Enterasys SecureStack B3 User Manual

clear ip address
3-10 Basic Configuration
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetthesystemIPaddressto10.1.10.1withamaskof255.255.128.0and
adefaultgatewayof10.1.0.1:
B3(su)->set ip address 10.1.10.1 mask 255.255.128.0 gateway 10.1.10.1
clear ip address
UsethiscommandtoclearthesystemIPaddress.
Syntax
clear ip address
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearthesystemIPaddress:
B3(rw)->clear ip address
show ip protocol
UsethiscommandtodisplaythemethodusedtoacquireanetworkIPaddressforswitch
management.
Syntax
show ip protocol
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.

Enterasys SecureStack B3 Specifications

General

Ports	24 or 48 10/100/1000BASE-T ports
Forwarding Rate	95.2 Mpps
Layer	Layer 2/3
Power Supply	Internal
Redundant Power Supply	Optional
VLANs Supported	4094
Uplink Ports	4 SFP ports
Dimensions	44.0 x 43.7 x 4.4 cm
Weight	11.9 lbs (5.4 kg)
MAC Address Table Size	16, 000 entries
Jumbo Frame Support	Up to 9, 216 bytes
Power over Ethernet	PoE+
Operating Temperature	0°C to 50°C
Storage Temperature	-20 °C to 70 °C
Humidity	10% to 95% (non-condensing)