Enterasys SecureStack B3

show lldp port location-info
4-18 Discovery Protocol Configuration
Example
ThisexampleshowshowtodisplaytransmitTLVinformationforthreeports.
B3(ro)->show lldp port tx-tlv ge.1.1-3
* Means TLV is supported and enabled on this port
o Means TLV is supported on this port
Means TLV is not supported on this port
Column Pro Id uses letter notation for enable: s-stp, l-lacp, g-gvrp
Ports Port Sys Sys Sys Mgmt Vlan Pro MAC PoE Link Max MED MED MED MED
Desc Name Desc Cap Addr Id Id PHY Aggr Frame Cap Pol Loc PoE
------- ---- ---- ---- --- ---- ---- ---- --- --- ---- ---- --- --- --- ---
ge.1.1 * * * * * * slg * * * * *
ge.1.2 * * * * * * slg * * *
ge.1.3 * * * * * * slg * * * * *
show lldp port location-info
Usethiscommandtodisplayconfiguredlocationinformationforoneormoreports.Portsare
configuredwithalocationvalueusingthesetlldpportlocation‐infocommand.
Syntax
show lldp port location-info [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,portlocationconfigurationinformationwillbedisplayedforall
ports.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplayportlocationinformationforthreeports.
B3(ro)->show lldp port location-info ge.1.1-3
Ports Type Location
-------- ------------- -------------------------
ge.1.1 ELIN 1234567890
ge.1.2 ELIN 1234567890
ge.1.3 ELIN 1234567890
show lldp port local-info
Usethiscommandtodisplaythelocalsysteminformat ionstoredforoneormoreports.Youcan
usethisinformationtodetectmisconfigurationsorincompatibilitiesbetweenthelocalportand
theattachedendpointdevice(remoteport).
port‐string (Optional)Displaysportlocationinformationforoneorarangeof
ports.