Enterasys SecureStack B3

show garp timer
SecureStack B3 Configuration Guide 8-21
show garp timer
UsethiscommandtodisplayGARPtimervaluesforoneormoreports.
Syntax
show garp timer [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,GARPtimerinformationwillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayGARPtimerinformationonports1through10inslot1:
B3(su)->show garp timer ge.1.1-10
Port based GARP Configuration: (Timer units are centiseconds)
Port Number Join Leave Leaveall
----------- ---------- ---------- ----------
ge.1.1 20 60 1000
ge.1.2 20 60 1000
ge.1.3 20 60 1000
ge.1.4 20 60 1000
ge.1.5 20 60 1000
ge.1.6 20 60 1000
ge.1.7 20 60 1000
ge.1.8 20 60 1000
ge.1.9 20 60 1000
ge.1.10 20 60 1000
Table 8‐3providesanexplanationofthecommandoutput.Fordetailsonusingthesetgvrp
commandtoenableordisableGVRP,referto“setgvrp”onpage 8‐22.Fordetailsonusingtheset
garptimercommandtochange defaulttimervalues,referto“setgarptimer”on
page 8‐23.
port‐string (Optional)DisplaysGARPtimerinformationforspecific port(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 5‐1.
Note: For a functional description of the terms join, leave, and leaveall timers, refer to the
standard IEEE 802.1Q documentation, which is not supplied with this device.
Table 8-3 show gvrp configuration Output Details
Output What It Displays...
Port Number Port designation. For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 5-1.
Join Join timer setting.
Leave Leave timer setting.
Leaveall Leavall timer setting.